    |
 |
Typical pulse processing electronics consist of a linear preamplifier located as close to the PMT or Channeltron as possible, linear amplifier, and a single channel analyzer used as a noise discriminator. The F-100E combines all three units into one, eliminating many controls, dials, and cables at a reduced cost but higher reliability and performance. Each unit also has an externally accessible threshold setting for noise discrimination. The output pulse width may be extended to meet minimum pulse width requirements of a given rate meter. |
| Maximum Pulse Repetition Rate | >100 MHz |
| Sensitivity | 100 µV |
| Input Impedance | 50 Ω |
| Input Noise Level | <20 µV |
| Input Pulse Polarity | Negative |
| Input Overvoltage Protection | Standard |
| Input Connector | BNC |
| Pulse Pair Resolution | <10 nSec |
| Minimum Output Pulse Width | 5 nSec |
| Output Impedance | 50 Ω |
| Output Signal | Complimentary ECL |
| Power and Signal Connector | 9 pin mini D type |
| Second Output Signal | Twin BNC |
| Power Requirements | ± 8VDC to ± 24VDC |
| Physical Size | 2.5"W x 5"L x 1.1"H |
| Domestic | International | |
| F-100E | $795.00 | $994.00 |
| Available options: | ||
| Linear amplifier output | ||
| remote threshold control | ||
| remote threshold monitor | ||